Description

 Featues:

1. The knife cylinder can provide stable, fast, and pressure-free knife movements.

2. The patented oil cup cover prevents oil injection and pressure loss during the knife-making process. It has the characteristics of light weight and high output, and it will not generate excessive temperature due to fast movements. The principle is to use lower air pressure to convert to higher oil pressure to achieve greater force output.

3. The sealing ring adopts imported products from Germany and Japan, which has excellent wear resistance and sealing performance.

4. The cylinder body is treated with hard film, which is wear-resistant and fast heat dissipation.

5. The solenoid valve adopts Taiwan Airtec, which is made in Taiwan as a whole, with excellent performance. It is widely used in CNC machine tools and other mechanical fields.

 SIZE:

Installation Precautions:

1. Make sure that the spindle end cannot be in contact with the tip of the pressurized cylinder when there is no broach.

2. When the spindle does not have a broach, the gap between the spindle end and the bumper end of the punch cylinder must be kept above 3mm.

3. After adjusting the amount of punching, it is necessary to tighten the two M5 bolts on the stopper.

4. It is recommended to use M10X55L for the knife cylinder and the bolts fixed on the fixed seat.

5. The air intake pressure should be maintained at 6kg/cm~7kg/cm.

6. The safe minimum amount of oil in the oil cup shall not be less than 1/2.

7. Use hydraulic oil number: SHELL TELLUS 32

8. The safe and effective contact amount of the micro switch is that after the roller touches the inductive bumper, then press down 1.5mm as the standard inductive amount.

9. Before use, please confirm whether the wiring voltage is consistent with the solenoid valve voltage.

10. The blow hole is equipped with a throttle valve to adjust the air volume.

11. After the installation is completed, test the action and pressure first. Before the power is turned on, the manual button of the solenoid valve can be used to test the pressure action to confirm the installation is correct.

12. When using, make sure that no air bubbles are left in the cylinder tube of the booster cylinder (because residual air in the cylinder tube will cause insufficient pressure). During the pressure test action test, check whether there are still bubbles in the oil cup. If there is chlorine Bubbles indicate that there is still air in the cylinder tube, and the pressure test must be continued until

Until there are no more bubbles in the oil cup, fill the oil in the oil cup to the 4/5 level at this time.

 [Maintenance precautions]：

1. Regularly check the volume of the oil cup.

2. Regularly check whether the fixing screws of the guard switch, the locking bolts of the hitting block and the fixing bolts of the booster cylinder are loose. If they ar