Answer: the technical parametersScope: select the classification (mm) motor type: permanent magnet dc motorRated power: 20 w idle speed line: 10 mm/SECRated voltage, maximum thrust DC24V: 75 kgTemperature: 15 ° c to + 60 ° c level of protection: IP54Push rod material: aluminum alloyMotor no-load speed: 4000 revolutions per minute encoder resolution: six pulse/roll

The corresponding motor pole 10 mm encoder emits 400 pulse signal receiver (that is, the buyer can receive signal number)

Can't travel control: to maximize the built-in adjustable stroke switch, the other one is equipped with photoelectric encoder output signal, buyers and other control mechanisms can be detecting the actual distance to achieve automatic control, the encoder data accurately check the attached product description

Duty: 10% (the maximum load of 2 minutes, 18 minutes must stop work, small work load time can be extended accordingly)

2. The size (mm)Example: 200 mm rod back total length 320 mm rod stroke the total length of 520 mm, and so on

3. The product description1. This series of dc electric push rod is widely used in electric nursing bed, bed operation, the traction bed, massage chair, dental chair, electric wheelchair, electric, electric sofa booth, electric sunroof, ergonomic furniture linear motor, easy installation, in medical, fire, household, electrical and mechanical, chemical, bathroom, leisure, and other fields are widely used.2. Support the use of hinged support, the pipe body clamp support, dedicated and reversing controller, single transformer, switch, speed governor, the fuse, the remote control can understand the details, click on the image below

The installation of two stents, common diagram

The encoder data:Bipolar pulse output electric putterPhotoelectric sensor bipolar pulse output electric putter.Relative single-phase electric putter pulse generation based on hall sensor output has the following advantages:1, based on the principle of photoelectric sensor, no external magnetic field interference, fundamentally solves the previous generation products are susceptible to interference of outside magnetic field pulse distortion caused by the disease2, quasi bipolar output (A and B phase difference of 90 degrees), solved the last generation products work cannot distinguish between positive and negative transfer3, in the digital circuit to realize high precision double standard square wave output, replaced the previous generation simulation approximate square wave output products4, each generation of the division of product precision motor pulse every six pulse5, shall be square wave pulse waveform output, easy to connect to the other control equipment6, no moving parts, no wear, long service life, fast7, encoder built-in imported high-speed microcontroller, to ensure the real-time and stability of the output waveformEight, the encoder signal output driving capability, do not use the shielded cable received relatively pure pulse signal

Standard of 5 v encoder performance indicators:Operating voltage: 4.2 6 vTo adapt to the car speed:Response time:Analytic: six pulse/rollOutput: A and B double standard square wave, 90 degreesTemperature: - 35 ~ + 85 degrees CelsiusEnvironmental humidity (relative) :

Wiring methods:Red line: + 5 v: DC5V power input, less as far as possible interference of the stable dc power supply inputWhite lines: A: pulse output, 5 v high level and low level 0 v, the standard square waveYellow line: B: pulse output, high level 5 v, the low level 0 v, the standard square waveBlack: grounding: the cathode

Ge (General electric) push rod 5, welcome to choose!!!!!!